Ip Ospf Mtu - Allied Telesis AT-AR3050S Command Reference Manual

OSPF C
OMMANDS

IP OSPF MTU

ip ospf mtu
Overview This command sets the MTU size for OSPF. Whenever OSPF constructs packets, it
uses VLAN interface MTU size as Maximum IP packet size. This command forces
OSPF to use the specified value, overriding the actual VLAN interface MTU size.
Use the no variant of this command to return the MTU size to the default.
Syntax ip ospf mtu <576-65535>
no ip ospf mtu
Default By default, OSPF uses interface MTU derived from the VLAN interface.
Mode Interface Configuration for a VLAN interface or a PPP interface.
Usage This command allows an administrator to configure the MTU size recognized by
the OSPF protocol. It does not configure the MTU settings on the VLAN interface.
OSPF will not recognize MTU size configuration changes made to the kernel until
the MTU size is updated through the CLI.
Example awplus#
awplus(config)#
awplus(config-if)#
awplus#
awplus(config)#
awplus(config-if)#
C613-50077-01 REV A
configure terminal
interface vlan2
ip ospf mtu 1480
configure terminal
interface pp0
ip ospf mtu 1480
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
779