Speed - Allied Telesis AT-AR3050S Command Reference Manual

S C
WITCHING OMMANDS

SPEED

speed
Overview This command changes the speed of the specified port. You can optionally specify
the speed or speeds that get autonegotiated, so autonegotiation is only
attempted at the specified speeds.
To see the currently-negotiated speed for ports whose links are up, use the
interface
default), use the
speed {10|100|1000|auto [10][100][1000]}
Syntax
The following table shows the speed options for each type of port.
Port type
RJ-45 and RJ.5copper ports
Mode Interface Configuration
Default By default, ports autonegotiate speed.
Usage Switch ports in a static or dynamic (LACP) channel group must have the same port
speed and be in full duplex mode. Once switch ports have been aggregated into a
channel group, you can set the speed of all the switch ports in the channel group
by applying this command to the channel group.
NOTE
then the device only attempts autonegotiation at those specified speeds.
Examples To set the speed of a tri-speed port to 100Mbps, enter the following commands:
awplus#
awplus(config)#
awplus(config-if)#
To return the port to auto-negotiating its speed, enter the following commands:
awplus#
awplus(config)#
awplus(config-if)#
To set the port to auto-negotiate its speed at 100Mbps and 1000Mbps, enter the
following commands:
awplus#
awplus(config)#
awplus(config-if)#
C613-50077-01 REV A
command. To see the configured speed (when different from the
show running-config
Speed Options (units are Mbps)
auto (default)
10
100
1000
: If multiple speeds are specified after the auto option to autonegotiate speeds,
configure terminal
interface port1.0.2
speed 100
configure terminal
interface port1.0.2
speed auto
configure terminal
interface port1.0.2
speed auto 100 1000
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
command.
show
425