Passive-Interface (Ipv6 Ospf) - Allied Telesis AT-AR3050S Command Reference Manual

OSPF 3 IP 6 C
V FOR V OMMANDS
- (IP 6 OSPF)
PASSIVE INTERFACE V

passive-interface (IPv6 OSPF)

Overview Use this command to suppress the sending of Hello packets on a specified
interface. If you use the passive-interface command without the optional
parameters then all interfaces are put into passive mode.
Use the no variant of this command to allow the sending of Hello packets on all
interfaces, or on the specified interface. If you use the no variant of this command
without the optional parameters then all interfaces are removed from passive
mode.
passive-interface [<interface>]
Syntax
no passive-interface [<interface>]
Mode Router Configuration
Usage Configure an interface to be passive if you wish its connected route to be treated
as an OSPF route (rather than an AS-external route), but do not wish to actually
exchange any OSPF packets via this interface.
Examples To configure passive interface mode on interface vlan2, enter the following
commands:
awplus(config)#
awplus(config-router)#
To configure passive interface mode on all interfaces, enter the following
commands:
awplus(config)#
awplus(config-router)#
To remove passive interface mode on interface vlan2, enter the following
commands:
awplus(config)#
awplus(config-router)#
To remove passive interface mode on all interfaces, enter the following
commands:
awplus(config)#
awplus(config-router)#
C613-50077-01 REV A
Parameter Description
<interface>
The name or the VID of the VLAN interface.
router ipv6 ospf
router ipv6 ospf
router ipv6 ospf
router ipv6 ospf
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
passive-interface vlan2
passive-interface
no passive-interface vlan2
no passive-interface
893