Host Area - Allied Telesis AT-AR3050S Command Reference Manual

OSPF C
OMMANDS

HOST AREA

host area
Overview This command configures a stub host entry belonging to a particular area. You can
use this command to advertise specific host routes in the router-LSA as stub link.
Since stub host belongs to the specified router, specifying cost is optional.
The no variant of this command removes the host area configuration.
Syntax host <ip-address> area <area-id> [cost <0-65535>]
no host <ip-address> area <area-id> [cost <0-65535>]
Default By default, no host entry is configured.
Mode Router Configuration
awplus#
Example
awplus(config)#
awplus(config-router)#
awplus(config-router)#
C613-50077-01 REV A
Parameter
<ip-address>
<area-id>
cost <0-65535>
configure terminal
router ospf 100
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
Description
The IPv4 address of the host, in dotted decimal notation.
The OSPF area ID of the transit area that configuring the stub
host entry for. Use one of the following formats:
• dotted decimal format, e.g. 0.0.1.2.
• normal decimal format in the range <0-4294967295>, e.g.
258.
The cost for the stub host entry.
host 172.16.10.100 area 1
host 172.16.10.101 area 2 cost 10
768