Ipv6 Ospf Hello-Interval - Allied Telesis AT-AR3050S Command Reference Manual

OSPF 3 IP 6 C
V FOR V OMMANDS
6 -
IPV OSPF HELLO INTERVAL

ipv6 ospf hello-interval

Overview This command specifies the interval between hello packets.
The hello-interval is advertised in the hello packets. Configure the same
hello-interval for all routers on a specific network. A shorter interval ensures faster
detection of topological changes, but results in more routing traffic.
The no variant of this command returns the interval to the default of 10 seconds.
ipv6 ospf hello-interval <1-65535>
Syntax
no ipv6 ospf hello-interval
Default The default interval is 10 seconds.
Mode Interface Configuration for a VLAN interface or Interface Configuration for a PPP
interface.
The following example shows setting the hello-interval to 3 seconds on the
Example
VLAN interface vlan2:
awplus#
awplus(config)#
awplus(config-if)#
The following example shows setting the hello-interval to 3 seconds on the
PPP interface ppp0:
awplus#
awplus(config)#
awplus(config-if)#
Related ipv6 ospf dead-interval
Commands
show ipv6 ospf interface
C613-50077-01 REV A
Parameter Description
<1-65535>
The hello-interval in seconds.
Default: 10
configure terminal
interface vlan2
configure terminal
interface ppp0
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
ipv6 ospf hello-interval 3
ipv6 ospf hello-interval 3
883