Debug Ipv6 Ospf Lsa - Allied Telesis AT-AR3050S Command Reference Manual

OSPF 3 IP 6 C
V FOR V OMMANDS
6
DEBUG IPV OSPF LSA

debug ipv6 ospf lsa

Overview This command enables debugging options for IPv6 OSPF Link State
Advertisements (LSA) troubleshooting. This displays information related to
internal operations of LSAs.
To enable all debugging options, specify debug ipv6 ospf lsa with no additional
parameters.
The no and undebug variants of this command disable IPv6 OSPF LSA debugging.
Use this command without parameters to disable all the options.
debug ipv6 ospf lsa [flooding] [generate] [install] [maxage]
Syntax
[refresh]
no debug ipv6 ospf lsa [flooding] [generate] [install] [maxage]
[refresh]
Mode Privileged Exec and Global Configuration
Examples To enable debugging for IPv6 OSPF refresh LSA, use the following commands:
awplus#
Related terminal monitor
Commands
undebug ipv6 ospf lsa
C613-50077-01 REV A
Parameter Description
flooding
Displays LSA flooding.
generate
Displays LSA generation.
install
Show LSA installation.
maxage
Shows maximum age of the LSA in seconds.
refresh
Displays LSA refresh.
debug ipv6 ospf lsa refresh
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
866