Distribute-List (Rip) - Allied Telesis AT-AR3050S Command Reference Manual

RIP C
OMMANDS
- (RIP)
DISTRIBUTE LIST

distribute-list (RIP)

Overview Use this command to filter incoming or outgoing route updates using the
prefix-list.
Use the no variant of this command to disable this feature.
Syntax distribute-list prefix <prefix-list> {in|out} [<interface>]
no distribute-list prefix <prefix-list> {in|out} [<interface>]
Default Disabled
Mode RIP Router Configuration
Usage Filter out incoming or outgoing route updates using prefix-list. If you do not
specify the name of the interface, the filter will be applied to all interfaces.
Examples In this example the following commands are used to apply an prefix list called
myfilter to filter incoming routing updates in vlan2
awplus#
awplus(config)#
awplus(config-router)#
C613-50077-01 REV A
Parameter Description
prefix
Filter prefixes in routing updates.
<prefix-list>
Specifies the name of the IPv4 prefix-list to use.
in
Filter incoming routing updates.
out
Filter outgoing routing updates.
<interface> The interface on which distribute-list applies. For instance: vlan2
configure terminal
router rip
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
distribute-list prefix myfilter in vlan2
666