Copy Debug - Allied Telesis AT-AR3050S Command Reference Manual

F M C
ILE ANAGEMENT OMMANDS

COPY DEBUG

copy debug
Overview This command copies a specified debug file to a destination file.
copy debug
Syntax
{<destination-name>card|debug|flash|nvs|scp|tftp|usb}
{<source-name>|debug|flash|nvs|scp|tftp|usb}
Mode Privileged Exec
To copy debug output to an SD (or SDHC) card with a filename my-debug, use the
Example
following command:
awplus#
To copy debug output to a USB storage device with a filename my-debug, use the
following command:
awplus#
Output Figure 2-2:
Related delete debug
Commands
move debug
C613-50077-01 REV A
Parameter
<destination-name>
<source-namee>
copy debug card:my-debug
copy debug usb:my-debug
CLI prompt after entering the copy debug command
Enter source file name []:
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
Description
The filename and path where you would like the debug
output saved. See Introduction
The filename and path where the debug output originates.
See Introduction on page 96 for valid syntax.
on page 96 for valid syntax.
111