Ipv6 Ospf Transmit-Delay - Allied Telesis AT-AR3050S Command Reference Manual

OSPF 3 IP 6 C
V FOR V OMMANDS
6 -
IPV OSPF TRANSMIT DELAY

ipv6 ospf transmit-delay

Overview Use this command to set the estimated time it takes to transmit a link-state-update
packet on the VLAN interface.
Use the no variant of this command to return to the default of 1 second.
Syntax ipv6 ospf transmit-delay <1-65535>
no ipv6 ospf transmit-delay
Default The default interval is 1 second.
Mode Interface Configuration for a VLAN interface or Interface Configuration for a PPP
interface.
Usage The transmit delay value adds a specified time to the age field of an update. If the
delay is not added, the time in which the LSA transmits over the link is not
considered. This command is especially useful for low speed links. Add
transmission and propagation delays when setting the transmit delay value.
Example To set the IPv6 OSPF transmit delay time to 3 seconds on the VLAN interface
vlan2, use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
To set the IPv6 OSPF transmit delay time to 3 seconds on the PPP interface ppp0,
use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
C613-50077-01 REV A
Parameter Description
<1-65535>
Specifies the time, in seconds, to transmit a link-state update.
configure terminal
interface vlan2
configure terminal
interface ppp0
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
ipv6 ospf transmit-delay 3
ipv6 ospf transmit-delay 3
889