Allied Telesis AT-AR3050S Command Reference Manual page 672

RIP C
OMMANDS
IP RIP AUTHENTICATION MODE
Usage: multiple For multiple keys authentication, use the following steps to configure a route to
key enable RIPv2 authentication using multiple keys at different times:
1)
2)
3)
4)
5)
Example 1 In the following sample multiple keys authentication RIP configuration, a
password toyota is set for key 1 in key chain cars. Authentication is enabled on
vlan2 and the authentication mode is set to MD5:
awplus#
awplus(config)#
awplus(config-keychain)#
awplus(config-keychain-key)#
awplus(config-keychain-key)#
2008 duration 43200
awplus(config-keychain-key)#
duration 43200
awplus(config-keychain-key)#
awplus(config-keychain)#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
awplus(confi-if)#
awplus(config)#
awplus#
C613-50077-01 REV A
Define a key chain with a key chain name, using the following commands:
awplus# configure terminal
awplus(config)# key chain <key-chain-name>
Define a key on this key chain using the following command:
awplus(config-keychain)#
Define the password used by the key, using the following command:
awplus(config-keychain-key)#
Enable authentication on the desired interface and specify the key chain to
be used, using the following commands:
awplus(config-if)#
<key-chain-name>
Specify the mode of authentication for the given interface (text or MD5),
using the following commands:
awplus(config-if)#
configure terminal
key chain cars
interface vlan2
ip rip authentication key-chain cars
ip rip authentication mode md5
exit
exit
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
key <keyid>
key-string <key-password>
ip rip authentication key-chain
ip rip authentication mode {md5|text}
key 1
key-string toyota
accept-lifetime 10:00:00 Apr 08
send-lifetime 10:00:00 Apr 08 2008
exit
exit
672