Neighbor (Rip) - Allied Telesis AT-AR3050S Command Reference Manual

RIP C
OMMANDS
(RIP)
NEIGHBOR

neighbor (RIP)

Overview Use this command to specify a neighbor router. It is used for each router to which
you wish to send unicast RIP updates.
Use the no variant of this command to stop sending unicast updates to the specific
router.
Syntax neighbor <ip-address>
no neighbor <ip-address>
Default Disabled
Mode Router Configuration
Usage Use this command to exchange nonbroadcast routing information. It can be used
multiple times for additional neighbors.
The
interface. Use the neighbor command in conjunction with the
(RIP)
Example To specify the neighbor router to 1.1.1.1, use the following command:
awplus#
awplus(config)#
awplus(config-router)#
awplus(config-router)#
Related passive-interface (RIP)
Commands
C613-50077-01 REV A
Parameter Description
<ip-address>
The IP address of a neighboring router with which the routing
information will be exchanged.
passive-interface (RIP)
to send routing updates to specific neighbors.
configure terminal
router rip
Command Reference for AT-AR3050S
AlliedWare Plus™ Operating System - Version 5.4.5-2.x
command disables sending routing updates on an
passive-interface vlan1
neighbor 1.1.1.1
passive-interface
689