Chrysler 2005 Crossfire SRT6 Service Manual page 312

5 - 146 BRAKES - ABS ELECTRICAL DIAGNOSTICS
1040-NO CAN COMMUNICATIONS WITH YAW RATE/ACCELERATION SENSOR (CONTINUED)
2.
MEASURE THE RESISTANCE OF THE S-CAN (-) CIRCUIT
With the ignition off.
Measure the resistance of the S-CAN (-) circuit from the CAB harness
connector to the Yaw Rate/Acceleration sensor harness connector.
Is the resistance below 1.0 ohm?
Yes >> Replace the Controller Antilock Brake (CAB) Module.
(Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL
MODULES/CONTROLLER
REMOVAL).
Perform ABS VERIFICATION TEST.
No >> Repair the S-CAN (-) circuit for an open.
Perform ABS VERIFICATION TEST.
ANTILOCK BRAKE -
ZH