CLICK HERE TO VIEW CHAPTER INDEX
EM- -82
ENGINE MECHANICAL
- -
31.
REMOVE PISTON RINGS
(a)
Using a piston ring expander, remove the 2 compression
rings and oil ring.
P11732
(b)
Remove the coil by hand.
HINT:
Arrange the rings in correct order only.
P11745
32.
DISCONNECT CONNECTING ROD FROM PISTON
(a)
Using a small screwdriver, pry off the snap ring form the
piston.
(b)
Gradually heat the piston to approx. 60˚C (140˚F).
Snap Ring
P11747
(c)
Using a plastic--faced hammer and brass bar, lightly tap
out the piston pin and remove the connecting rod.
HINT:
The piston pin are matched set.
S
Arrange the pistons, pins, rings, connecting rods and
S
bearings in correct order.
EM8525
CYLINDER BLOCK
1KZ-TE
Pages From Manual
TO MODEL INDEX