Front Jogging Motor Abnormality/Front Aligning Plate Motor Abnormality; (Front Aligning Plate Motor Abnormality); Rear Alignment Motor Abnormality - Toshiba e-STUDIO281c Service Handbook

[CC80] Front jogging motor abnormality/Front aligning plate motor abnormality
MJ-1022 (Front jogging motor abnormality)
Is the front jogging plate home position sensor (S6) working properly?
NO Replace the sensor.
YES
Is the wiring between the finisher controller PC board and front jogging motor (M3) correct?
NO Correct the wiring.
YES
Has the rack run over the stopper of the roll?
YES Fix it.
NO
1) Replace the front jogging motor.
2) Replace the finisher controller PC board.
MJ-1023/1024 (Front aligning plate motor abnormality)
Is the front aligning plate home position sensor (PI36) normal?
NO Replace the sensor.
YES
Is the wiring between the finisher controller PC board and the front aligning plate motor (M33)
correct?
NO Correct the wiring.
YES
Is there any mechanical problem with the path of aligning plate?
NO Fix the mechanism.
YES
1) Replace the front aligning plate motor.
2) Replace the finisher controller PC board.
[CC80] Rear alignment motor abnormality
* You receive a [CC80] error when the [ED14] error occurs three times in succession.
MJ-1101
Is there any mechanical problem when the rear alignment plate is moved?
YES Fix the mechanism.
NO
Is the harness between the rear alignment motor (M10) and the finisher control PC board
(CN10) disconnected or open circuited?
l YES •
•
NO
1) Replace the rear alignment motor (M10).
2) Replace the finisher control PC board.
e-STUDIO281c/351c/451c
TROUBLESHOOTING
Reconnect the connector securely.
Replace the harness.
5 - 80
06/08
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved