Dip Switch Functions - Toshiba e-STUDIO281c Service Handbook

3.13.7

DIP switch functions

You can simulate various functions by setting the DIP switch (SW1) on the finisher controller PC board
appropriately.
Initiating Operations
1) Remove any obstacles from the area of operation.
2) Set the DIP switch (SW1) as shown, and turn ON the power (so that LED1 will start to blink).
3) Press the pushing switch (SW2) twice to initiate the operation in question. (LED2 will remain on dur-
ing operation).
Setting
Delivery motor
ON
1 2 3 4 5 6 7 8
Stack processing
motor (stack
ON
delivery lever)
1 2 3 4 5 6 7 8
Stack processing
motor (returning
ON
roller)
1 2 3 4 5 6 7 8
Front jogging
plate motor
ON
1 2 3 4 5 6 7 8
Rear jogging
plate motor
ON
1 2 3 4 5 6 7 8
Upper stack tray
motor (up)
ON
1 2 3 4 5 6 7 8
Upper stack tray
motor (down)
ON
1 2 3 4 5 6 7 8
Lower stack tray
motor (up)
ON
1 2 3 4 5 6 7 8
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Item Operation
The delivery roller rotates in a specific
speed.
The stack delivery lever moves to its
home position and stops.
The returning roller moves to the home
position and stops.
When not at the
home position
When at the
home position
When not at the
home position
When at the
home position
The upper stack tray moves up and stops
when the upper stack tray upper limit
sensor turns ON.
The upper stack tray moves down and
stops when the lower stack tray lower
limit sensor turns ON.
The lower stack tray moves up and stops
when the lower stack tray upper limit
sensor is turned ON.
3 - 87
•
•
•
•
The front jogging plate •
moves to its home
position and stops.
The front jogging plate •
moves over a specific
position and stops at
the home position.
The rear jogging plate •
moves to the home
position and stops.
The rear jogging plate •
moves over a specific
distance and stops.
•
•
•
•
•
•
To stop
Press SW2 again.
Turn OFF the joint
sensor (S4).
Turn OFF the joint
sensor (S4).
Turn OFF the joint
sensor (S4).
Turn OFF the joint
sensor (S4).
Turn OFF the joint
sensor (S4).
Turn OFF the joint
sensor (S4).
Turn OFF the joint
sensor (S4).
Press SW2 again.
Turn OFF the joint
sensor (S4).
Press SW2 again.
Turn OFF the joint
sensor (S4).
Press SW2 again.
Turn OFF the joint
sensor (S4).
e-STUDIO281c/351c/451c
ADJUSTMENT
3