3.12.2
Adjusting the angle of the jogging plate
<Procedure>
(1)
Without removing the processing tray unit,
loosen the 2 mounting screws of the rear jog-
ging plate.
(2)
Place several sheets of A4/LT paper on the
processing tray, and adjust the rear jogging
plate. (At this time, adjust the gap between
the paper and the front end of the rear jog-
ging plate so that it is 0 mm to 0.5 mm.)
(3)
With reference to the rear jogging plate
adjusted in step (2), adjust the front jogging
plate in the same manner.
© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved
Screw
Fig. 3-114
Paper
Butted
Finisher
Fig. 3-115
e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283
3 - 87
Rear jogging plate
0 mm to 0.5 mm
Screw
Rear jogging
plate
ADJUSTMENT
3