Rack Gear, Pinion Gear (Aligning Plate); Finishing Tray Shaft; Movable Tray Drive Gear - Toshiba e-STUDIO281c Service Handbook

* q4.

Rack gear, pinion gear (Aligning plate)

* q5.

Finishing tray shaft

1) Take off the metal shield plate.
* If the hole punch unit is installed, take it off beforehand.
2) Apply oil as follows through the opening which shows up when the metal shield plate
has been removed.
Apply an adequate amount of white grease (Molykote EM-30L) to the gear teeth of the
rack and pinion gears which drive the aligning plate, and the entire finishing tray shaft.
Pinion gear
* q6.

Movable tray drive gear

Apply an adequate amount of white grease (Molykote EM-30L) to the gear teeth of the
gear-A and gear-B.
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Rack gear
Fig. 4-30
Gear B
Gear A
Fig. 4-31
4 - 29
06/08
Finishing tray shaft
e-STUDIO281c/351c/451c
PREVENTIVE MAINTENANCE (PM)
4