Feed Signal Reception Jam; Jam Not Reaching The Read Sensor - Toshiba e-STUDIO281c Service Handbook

[E714] Feed signal reception jam
Is the empty sensor working? (Perform the input check: 03-[FAX]ON/[7]/[B])
YES Clean the rollers or replace them.
NO
Is the original excessively curled or folded?
YES Flatten and set it again.
NO
Are the original length sensor and registration sensor working?
(Perform the input check: 03-[FAX]ON/[8]/[E], [7]/[H])
| NO 1) Check if the lever of empty sensor is working normally.
|
2) Check if the connector of the empty sensor is disconnected.
|
3) Check if the connector CN75 on the RADF board is disconnected.
|
4) Check if the connector pins are disconnected or the harnesses are open
|
|
5) Check if the conductor pattern on the RADF board is short circuited or open
|
|
6) Replace the empty sensor.
|
7) Replace the RADF board.
|
YES
Replace the RADF board.
[E721] Jam not reaching the read sensor
Are the registration roller and read roller stained?
YES Clean the rollers.
NO
Is the read sensor working? (Perform the input check: 03-[FAX]ON/[7]/[G])
| NO 1) Check if the connector of the read sensor are disconnected.
|
2) Check if the connector CN75 on the RADF board is disconnected.
|
3) Check if the connector pins are disconnected or the harnesses are open
|
|
4) Check if the conductor pattern on the RADF board is short circuited or open
|
|
5) Replace the read sensor.
|
6) Replace the RADF board.
|
YES
Replace the RADF board.
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
circuited.
circuited.
circuited.
circuited.
5 - 25
e-STUDIO281c/351c/451c
TROUBLESHOOTING
5