General Descriptions For Pm Procedure - Toshiba e-STUDIO281c Service Handbook

4.2

General Descriptions for PM Procedure

(1) Preparation
• Ask the user about the current conditions of the equipment and note them down.
• Before starting maintenance, make some sample copies and store them.
• See the replacement record and check the parts to be replaced in the PM support mode (6S-
2) or list printing mode (9S-103).
6S-2 : [6] + [START] + [POWER] ON
9S-103 : [9] + [START] + [POWER] ON
PM SUPPORT CODE LIST
XX-XX-'XX 11:28
UNIT
DRUM
DRUM BLADE
DRUM BRUSH
GRID
MAIN CHARGER WIRE
WIRE CLEANING PAD
• Turn OFF the power and make sure to unplug the equipment.
(2) Perform a preventive maintenance using the following checklist and illustrations. Refer to the
Service Manual if necessary.
(3) Plug in the equipment after the maintenance has been finished. Then turn ON the power and
make some copies to confirm that the equipment is working properly.
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
[2]
[103]
OUTPUT PAGES/ PM OUTPUT PAGE/
DEVELOP COUNTS DEVELOP COUNTS
22220 200000
22220 200000
22220 200000
22220 200000
22220 200000
22220 200000
Fig. 4-7
4 - 9
[START]
[START]
DRIVE COUNTS PM DRIVE COUNTS
30948 320000
30948 320000
30948 320000
30948 320000
30948 320000
30948 320000
e-STUDIO281c/351c/451c
PREVENTIVE MAINTENANCE (PM)
4