2.2.5
Setting mode (08)
The items in the setting code list can be set or changed in this setting mode (08).
When the power should be turned OFF, be sure to shut down the equipment by pressing the
[ENERGY SAVER] button for a few seconds.
Procedure 1
[0][8]
[Digital key]
[POWER]
(Code)
* Press [FUNCTION CLEAR] to enter minus (-).
Procedure 2
[0][8]
[Digital key]
[POWER]
(Code)
Procedure 3
[0][8]
[Digital key]
[POWER]
(Code)
[CANCEL] or [CLEAR]
Procedure 4
[0][8]
[Digital key]
[POWER]
(Code)
* Press [FUNCTION CLEAR] to enter minus (-).
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
[CANCEL]
[Digital key]
[START]
*[FUNCTION CLEAR]
Sets or
changes value
[START]
[INTERRUPT]
Adjustment value
cannot be changed
[ENTER]
[START]
or
[INTERRUPT]
(Stores value in RAM)
[CANCEL]
[START]
[Digital key]
[START]
[START]
(Sub-code)
[CLEAR]
(Corrects value)
2 - 87
[ENTER]
or
[INTERRUPT]
(Stores value in RAM)
[CLEAR]
(Corrects value)
[ENTER]
[POWER]OFF/ON
or
(Exit)
(Automatic setting)
[ENTER]
[Digital key]
[INTERRUPT]
* [FUNCTION CLEAR]
(Stores value
Sets or
in RAM)
changes value
[CLEAR]
(Corrects value)
ERROR CODE AND SELF-DIAGNOSTIC MODE
[POWER] OFF/ON
(Exit)
[POWER] OFF/ON
(Exit)
[POWER]
or
OFF/ON
(Exit)
e-STUDIO281c/351c/451c
2