Toshiba e-STUDIO281c Service Handbook page 591

(11) Set the DIP-SW4 on the hole punch control PC board to OFF.
Note: Note:
When the number of blinks is other than "6" (which indicates that the adjustment value is "0") at
the section "1. Checking the hole punch position", follow the steps of "5.1 Stopping Position
Adjustment" in the MJ-6101 Service Manual to adjust the value to the one that has been set
before the update.
(12) Change the settings of the DIP-SW1 and -SW2 on the hole punch control PC board according to
the model as shown in the figure below.
(13) Install the rear cover of the hole punch unit.
(14) Install the rear lower cover of the hole punch unit.
(15) Install the finisher board access cover.
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
MJ-6101E MJ-6101N
ON
1 2 3 4
MJ-6101F MJ-6101S
ON
1 2 3 4
Fig. 6-38
6 - 33
06/08
ON
1 2 3 4
ON
1 2 3 4
e-STUDIO281c/351c/451c
FIRMWARE UPDATING
6