Toshiba e-STUDIO281c Service Handbook page 365

(5) Press [Button 1] to adjust the stapling position.
Every time [Button 1] is pressed, the alignment plate shifts 4 steps (0.45 mm) toward the "+"
direction. (It moves toward the rear side.)
Adjustment range is from -20 to +20 steps. If [Button 1] is pressed when the alignment position is
at the "+20 steps", the plate will return to the home position and then moves to the position of "-
20 steps".
Note: Note:
Stapling for checking the position can be done by pressing [Button 2] with sheets placed on the
finishing tray. (stapled on the rear side)
(6) When the adjustment is completed, press [Button 2] on the finisher control panel to store the
adjustment value in memory without sheets on the finishing tray.
When the value is stored normally, [LED 1] on the control panel will blink for a number of times
that corresponds to the adjustment value set for the equipment.
See the following table for the number of times [LED 1] blinks and its corresponding adjustment
value.
(7) Turn OFF the power of the equipment.
(8) Turn OFF all bits of the SW1 on the Finisher control board.
(9) Install the board access cover.
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
LED3 LED2
Button1
Fig. 3-98
Number of blinking
1
2
3
4
5
6
7
8
9
10
11
3 - 99
06/08
LED1
Button2
Adjustment value
-20
-16
-12
-8
-4
0
+4
+8
+12
+16
+20
e-STUDIO281c/351c/451c
ADJUSTMENT
3