Toshiba e-STUDIO281c Service Handbook page 26

Error code Classification
E420 Cover open jam
E430
E440
E450
E480
E510 Paper transport jam
(ADU section)
E520
E550 Other paper jam
E712 RADF jam
E713
E714
E721
E722
E724
E725
E731
E860
E870
e-STUDIO281c/351c/451c
ERROR CODE AND SELF-DIAGNOSTIC MODE
Contents
PFP side cover open jam: The PFP side cover has
opened during printing.
ADU open jam: The ADU has opened during print-
ing.
Side cover open jam: The side cover has opened
during printing.
LCF side cover open jam: The LCF side cover has
opened during printing.
Bridge unit open jam: The bridge unit has opened
during printing.
Jam not reaching the ADU entrance sensor: The
paper does not reach the ADU entrance sensor
after it is switchbacked in the exit section.
Stop jam in the ADU: The paper does not reach the
ADU exit sensor after it has passed the ADU
entrance sensor.
Paper remaining jam on the transport path: The
paper is remaining on the transport path when print-
ing is finished (caused by a multiple paper feeding).
Jam not reaching the original registration sensor:
The original fed from the original feeding tray does
not reach the original registration sensor.
Cover open jam in the read ready status: Jam
caused by opening of the RADF jam access cover
or front cover while the RADF is waiting for the
scanning start signal from the equipment.
Feed signal reception jam: The feed signal is
received even no original exists on the original
feeding tray.
Jam not reaching the read sensor: The original
does not reach the read sensor after it has passed
the registration sensor (when scanning obverse
side) or the reverse sensor (when scanning reverse
side).
Jam not reaching the original exit/reverse sensor
(during scanning): The original which passed the
read sensor does not reach the original exit/reverse
sensor when it is transported from the scanning
section to exit section.
Stop jam at the original registration sensor: The
trailing edge of the original does not pass the origi-
nal registration sensor after its leading edge has
reached this sensor.
Stop jam at the read sensor: The trailing edge of the
original does not pass the read sensor after its lead-
ing edge has reached this sensor.
Stop jam at the original exit/reverse sensor: The
trailing edge of the original does not pass the origi-
nal exit/reverse sensor after its leading edge has
reached this sensor.
RADF jam access cover open: The RADF jam
access cover has opened during RADF operation.
RADF open jam: RADF has opened during RADF
operation.
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
2 - 4
06/08
Troubleshooting
P. 5-21
P. 5-21
P. 5-22
P. 5-22
P. 5-23
P. 5-14
P. 5-15
P. 5-19
P. 5-24
P. 5-24
P. 5-25
P. 5-25
P. 5-26
P. 5-26
P. 5-27
P. 5-27
P. 5-27
P. 5-28