Toshiba e-STUDIO281c Service Handbook page 358

(4) Before inserting the paper, mark the top of the paper. You will be using two sheets of A3 or LD
paper.
(5) Turn ON the power.
(6) Press SW1 on the saddle stitcher controller PC board so that the feed motor (M1) starts to rotate.
(Press SW1 three seconds or more if LD paper is used.)
(7) Open the inlet cover and insert two sheets of paper. Push them in by hand until the front edge of
the sheets push against the paper positioning plate.
(8) Close the inlet cover.
(9) Press SW1 on the saddle stitcher controller PC board.
• The saddle stitcher unit will "stitch" the sheets, and fold and deliver the stack automatically.
e-STUDIO281c/351c/451c
ADJUSTMENT
A3/LD paper
Insert direction
Fig. 3-88
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
3 - 92
Mark