Procedure To Key In Adjustment Values - Toshiba e-STUDIO281c Service Handbook

[Procedure to key in adjustment values]

In accordance with the procedure described below, make adjustment of each adjustment item so that
the measured values obtained from test copies satisfy the specification. By pressing the [FAX] button,
immediately after starting the Adjustment Mode (05), single-sided test copying can be performed (nor-
mal copy mode).
<Operation keys>
0 5
POWER
1
Digital keys : Key in codes.
START
Digital keys : Key in adjustment
values.
( CLEAR Use to make corrections)
Value ZZZ is stored
ENTER
replacing values YYY.
or
INTERRUPT
FAX
Test copy
START
If the test copy does not
satisfy the specified values,
return to step 1 and
repeat the adjustment
procedure.
Power OFF/ON : Exit the Adjustment Mode.
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
<Display>
A
100%
TEST MODE
Code No.
XXX
100%
TEST MODE
YYY ZZZ
Current adjustment value
A
100%
TEST MODE
A
100%
Wait Warming Up
A
100%
COPYING
Fig. 3-2
3 - 7
A3
A3
Adjustment value newly keyed in.
(If no entering, YYY is displayed.)
A3
A3
A3
e-STUDIO281c/351c/451c
ADJUSTMENT
3