Top Margin; Right Margin - Toshiba e-STUDIO281c Service Handbook

(6) If not, use the following procedure to change values and repeat step 3. to 5. above.
<Procedure>
(Adjustment Mode) → (Key in the code [305]) → [START]
→ (Key in a value (acceptable values: 92 to 164))
→ [ENTER] or [INTERRUPT] (Stored in memory)
* The larger the adjustment value is, the longer the distance D becomes (approx. 0.14
mm/step).
[F]

Top margin

While pressing [0] and [5] simultaneously, turn the power ON. → (Adjustment Mode)
(1)
(2) Open the platen cover or RADF.
Press [FAX] → [START] to make a copy at the mode of A3/LD, 100%, Black, Text/Photo and
(3)
lower drawer.
(4) Measure the blank area E at the leading edge of the copied image.
(5) Check if the blank area E is within the range of 3±0.5 mm.
(6) If not, use the following procedure to change values and repeat the steps 3. to 5. above.
<Procedure>
(Adjustment Mode) → (Key in the code [430]) → [START]
→ (Key in a value (acceptable values: 0 to 255))
→ [ENTER] or [INTERRUPT] (Stored in memory)
→ ("100% A" is displayed.)
* The larger the adjustment value is, the wider the blank area becomes (approx. 0.04 mm/
step).
[G] Right margin
While pressing [0] and [5] simultaneously, turn the power ON. → (Adjustment Mode)
(1)
(2) Open the platen cover or RADF.
Press [FAX] → [START] to make a copy at the mode of A3/LD, 100%, Black, Text/Photo and
(3)
lower drawer.
(4) Measure the blank area F at the right side of the copied image.
(5) Check if the blank area F is within the range of 2+1 mm, 2-0.5 mm.
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Feeding direction
E
Fig. 3-7
3 - 17
07/04
e-STUDIO281c/351c/451c
ADJUSTMENT
3