Adjusting The Angle Of The Jogging Plate - Toshiba e-STUDIO351c Service Handbook

3.13.2

Adjusting the angle of the jogging plate

(1) Without removing the processing tray unit,
loosen the 2 mounting screws of the rear jog-
ging plate.
(2) Place several sheets of A4/LT paper on the
processing tray, and adjust the rear jogging
plate. (At this time, adjust the gap between
the paper and the front end of the rear jog-
ging plate so that it is 0 mm to 0.5 mm.)
(3) With reference to the rear jogging plate adjusted in step (2), adjust the front jogging plate in the
same manner.
e-STUDIO281c/351c/451c ADJUSTMENT
Screw
Paper
Butted
3 - 80
Rear jogging plate
Fig.3-71
0 mm to 0.5 mm
Screw
Rear jogging
plate
Fig.3-72
June 2005 © TOSHIBA TEC