3.12.3
Adjustment of Skew
Note:
Note:
Check if the image adjustment for the equipment is performed properly before this adjustment of
the RADF. Also, the RADF position and height shall be adjusted properly.
[A]
Checking
Check the image using the chart (original) with vertical and horizontal lines in the following procedure.
Simplex copying:
(1)
Place the chart provided as an original with its face up on the original tray of the RADF, select [1
Sided -> 1 Sided] and press the [START] button.
(2)
Superimpose the chart on the copy and check the inclination of the copy image.
Duplex copying:
(1)
Place the chart provided as an original with its face up on the original tray of the RADF, select [2
Sided -> 2 Sided] and press the [START] button.
(2)
Superimpose the chart on the copy and check the inclination of the copy image.
e-STUDIO281c/351c/451c
ADJUSTMENT
Fig. 3-52 Chart (Original)
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
3 - 70