Stapling Jam - Toshiba e-STUDIO281c Service Handbook

[EA50] Stapling jam
MJ-1022
Is there any paper remaining on the transport path in the finisher or equipment or on the sta-
pling tray?
YES
NO
Is the jam cleared by taking off the staple cartridge from the finisher and removing the staple
sheet slid from the staple case?
YES
NO
Is the connector J8 on the finisher controller PC board disconnected?
Is the harness connecting the finisher controller PC board and stapling home position sensor
(S17) open circuited?
YES
NO
Is the stapling home position sensor working properly?
| NO
|
YES
Replace the finisher controller PC board.
MJ-1023/1024
Is there any paper remaining on the transport path in the finisher or equipment or on the sta-
pling tray?
YES
NO
Is the jam cleared by taking off the staple cartridge from the finisher and removing the staple
sheet slid from the staple case?
YES
NO
Is the connector J721B on the finisher controller PC board disconnected?
Is the harness connecting the finisher controller PC board and staple home position sensor
(PI40) open circuited?
YES
NO
Is the staple home position sensor working properly?
| NO
|
YES
Replace the finisher controller PC board.
e-STUDIO281c/351c/451c
TROUBLESHOOTING
Remove the paper.
End.
Connect the connector securely. Replace the harness.
1) Connect the connector of the stapling home position sensor securely.
2) Replace the stapling home position sensor.
Remove the paper.
End.
Connect the connector securely. Replace the harness.
1) Connect the connector of the staple home position sensor securely.
2) Replace the staple home position sensor.
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
5 - 38