Paper Feeding System Related Service Call; Pfp Motor Abnormality - Toshiba e-STUDIO281c Service Handbook

5.1.9

Paper feeding system related service call

[C040] PFP motor abnormality
Is the PFP motor working? (Perform the output check: 03-109/159)
| NO 1) Check if the signal line connector CN503 of the PFP motor is disconnected.
|
2) Check if the power line connector CN502 of the PFP motor is disconnected.
|
3) Check if the connector CN246 on the PFP board is disconnected.
|
4) Check if the signal line connector CN241 on the PFP board is discon-
|
|
5) Check if the power line connector CN242 on the PFP board is discon-
|
|
6) Check if the connector CN332 on the LGC board is disconnected.
|
7) Check if the connector pins are disconnected or the harnesses are open
|
|
8) Check if the conductor patterns on the PFP motor board, PFP board and
|
|
|
9) Replace the PFP motor.
|
10)Replace the PFP board.
|
11)Replace the LGC board.
|
YES
Is the LED on the PFP motor board lit without flashing?
| NO 1) Check if the connector pins are disconnected or the harnesses are open
|
|
2) Check if the conductor patterns on the PFP motor board, PFP board and
|
|
3) Replace the PFP motor.
|
4) Replace the PFP board.
|
5) Replace the LGC board.
|
YES
1) Check if the PLL lock signal CN246-8 pin output from the PFP board is always "L" level.
2) Check if the voltage supplied to the microcomputer input terminal IC5-17 pin is always "L"
level.
3) Replace the PFP board.
4) Replace the LGC board.
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
nected.
nected.
circuited.
LGC board are short circuited or open circuited.
circuited.
LGC board are short circuited or open circuited.
5 - 53
e-STUDIO281c/351c/451c
TROUBLESHOOTING
5