Color Auto-Toner Sensor Abnormality - Toshiba e-STUDIO281c Service Handbook

[CF50] Color auto-toner sensor abnormality
Are the connector of color auto-toner sensor, joint connector and connector CN356 on the LGC
board connected normally?
| NO 1) Reconnect the connectors.
|
2) Correct or replace if the connector pins are disconnected or harnesses are
|
YES
Are the color auto-toner sensor and reference plate stained?
YES Clean them.
NO
Is the color auto-toner sensor shutter solenoid working normally?
(Perform the output check: 03-125/175)
| NO 1) Check if the connectors or joint connectors of the color auto-toner sensor
|
|
2) Check if the connector CN332 on the LGC board is disconnected.
|
3) Check if the connector pins are disconnected or the harnesses are open cir-
|
|
4) Check if the conductor pattern on the LGC board is short circuited or open
|
|
5) Replace the color auto-toner sensor shutter solenoid.
|
6) Replace the LGC board.
|
YES
Is the color auto-toner sensor shutter closing position correct?
(Perform the output check: 03-125/175)
| NO Adjust the install position of solenoid so that the gap between the sensor holder
|
and stopper will be 1.0 mm when closing the shutter.
YES
1) Check if the conductor pattern on the LGC board is short circuited or open circuited.
2) Replace the LGC board.
3) Replace the reference plate and perform "Initialization of color auto-toner sensor light
amount correction target value (05-207)".
4) Replace the color auto-toner sensor and perform "Enforced correction of color auto-toner
sensor light amount (05-208)".
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
open circuited.
shutter solenoid and color auto-toner sensor are disconnected.
cuited.
circuited.
5 - 97
e-STUDIO281c/351c/451c
TROUBLESHOOTING
5