3.4.3
Printer related adjustment
The printer related adjustment is performed by using the printed out grid pattern.
Adjustment
Tolerance
A
200 ± 0.5mm
B
52 ± 0.5mm
C
200 ± 0.5mm
D
52 ± 0.5mm
E
52 ± 0.5mm
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
1
6
B, E
Fig. 3-3
Refer to "[A] Reproduction ratio of primary scanning direction (Fine adjustment of
polygonal motor rotation speed (Printer))"
Refer to "[B] Primary scanning data laser writing start position (Printer)"
Refer to "[C] Reproduction ratio of secondary scanning direction (Fine adjustment
of main motor rotation speed (Printer))"
Refer to "[F] Secondary scanning data laser writing start position"
Refer to "[G] Primary scanning data laser writing start position at duplexing"
3 - 9
05/11
21
A
Detail of adjustment
e-STUDIO281c/351c/451c
ADJUSTMENT
3