[EA31] Transport path paper remaining jam
MJ-1101
Is there any paper remaining on the transport path in the finisher or equipment?
YES
Remove the paper.
NO
Is there a disconnection of the connector, incorrect installation or breakage of the transport
sensor (S2)?
l
YES
•
l
•
•
NO
Is the harness between the transport sensor (S2) and the finisher control PC board (CN22)
disconnected or open circuited?
l
YES
•
•
NO
Replace the finisher control PC board.
[EA32] Exit paper remaining jam
MJ-1101
Is there any paper remaining on the transport path in the finisher or equipment?
YES
Remove the paper.
NO
Is there a disconnection of the connector, incorrect installation or breakage of the finishing tray
paper detection sensor (S12)?
l
YES
•
l
•
•
NO
Is the harness between the finishing tray paper detection sensor (S12) and the finisher control
PC board (CN11) disconnected or open circuited?
l
YES
•
•
NO
Replace the finisher control PC board.
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Connect the connector securely.
Reinstall the sensor correctly.
Replace the sensor.
Reconnect the connector securely.
Replace the harness.
Connect the connector securely.
Reinstall the sensor correctly.
Replace the sensor.
Reconnect the connector securely.
Replace the harness.
5 - 35
06/08
e-STUDIO281c/351c/451c
TROUBLESHOOTING
5