YES
Connect the connector securely. Replace the harness.
NO
Are the upper and front door switches working properly?
|
NO
1) Connect the connectors of the upper and front door switches securely.
|
2) Replace the upper/front door switches.
YES
Replace the finisher controller PC board.
MJ-1101
Is the front cover or stationary tray cover opened?
l
YES
•
•
NO
Is there any breakage of the front cover hook which switches the front cover switch (SW1) to
ON?
YES
Replace the handle cover.
NO
Is there a disconnection of the connector, incorrect installation or breakage of the front cover
switch (SW1)?
Is there an incorrect installation or breakage of the stationary tray cover opening/closing switch
(SW2)?
l
YES
•
l
•
•
NO
Is the harness between the front cover switch (SW1) / stationary tray opening/closing switch
(SW2) and the finisher control PC board (CN16) disconnected or open circuited?
l
YES
•
•
NO
Replace the finisher control PC board.
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Close the front cover.
Close the stationary tray cover.
Connect the connector securely.
Reinstall the sensor correctly.
Replace the sensor.
Reconnect the connector securely.
Replace the harness.
5 - 37
06/08
e-STUDIO281c/351c/451c
TROUBLESHOOTING
5