Adjustment For Short-Sized Paper - Toshiba e-STUDIO281c Service Handbook

[G-2]

Adjustment for short-sized paper

While pressing [0] and [5] simultaneously, turn the power ON. → (Adjustment Mode)
(1)
Press [3] → [FAX]. (A grid pattern with 10 mm squares is printed out. Use A4/LT from the upper
(2)
drawer.)
(3) Check the grid pattern on the test print and measure the distance E from the left edge of the
paper to the 6th line of the grid pattern.
(4) Check if the distance E is within 52±0.5 mm.
(5) If not, use the following procedure to change values and measure the distance E again.
<Procedure>
(Adjustment Mode) → (Key in the code [498]) → [START] → [1] → [START]
→ (Key in a value (acceptable values: 0 to 255))
→ [ENTER] or [INTERRUPT] (Stored in memory)
→ "100% A" is displayed
→ Press [3] → [FAX] → (A grid pattern is printed out.)
* The larger the adjustment value is, the longer the distance E becomes (approx. 0.04 mm/
step).
<Adjustment procedure summarization for A to E>
[0] [5] [Power ON] → [1] ([3](05-445, 498) for duplexing) → [FAX]
A: 05-401 (Lower drawer, A3/LD)
B: 05-411 (Lower drawer, A3/LD)
C: 05-421 (Lower drawer, A3/LD)
D: 05-440 (Upper drawer, A4/LT)
441 (Lower drawer, A3/LD),
442 (Bypass feed, A4/LT),
443 (LCF, A4/LT), 444 (PFP, A4/LT),
445 (Duplexing, A3/LD)
E: 05-498-0 (Lower drawer, A3/LD),
498-1 (Upper drawer, A4/LT)
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
→ 200±0.5 mm (0.1 mm/step)
→ 52±0.5 mm (0.04 mm/step)
→ Key in the same value for 05-410.
→ 200±0.5 mm (0.5 mm/6 steps)
→ 52±0.5 mm (0.2 mm/step)
→ 52±0.5 mm (0.04 mm/step)
3 - 13
e-STUDIO281c/351c/451c
ADJUSTMENT
3