Lower Drawer Misfeeding - Toshiba e-STUDIO281c Service Handbook

[E140] Lower drawer misfeeding (paper not reaching the lower drawer feed sensor)
Open the side cover. Is there any paper in front of the lower drawer feed sensor?
YES
NO
Is the lower drawer feed sensor working? (Perform the input check: 03-[FAX]ON/[3]/[G])
| NO
|
|
|
|
|
|
|
|
YES
Is the lower drawer feed clutch working? (Perform the output check: 03-202)
| NO
|
|
|
|
|
|
|
|
YES
Check the lower drawer feed roller, separation roller and pickup roller. Replace them if they are
worn out.
e-STUDIO281c/351c/451c
TROUBLESHOOTING
Remove the paper.
1) Check if the connector of the lower drawer feed sensor is disconnected.
2) Check if the connector CN338 on the LGC board is disconnected.
3) Check if the connector pins are disconnected or the harnesses are open
circuited.
4) Check if the conductor pattern on the LGC board is short circuited or open
circuited.
5) Replace the lower drawer feed sensor.
6) Replace the LGC board.
1) Check if the connector of the lower drawer feed clutch is disconnected.
2) Check if the connector CN341 on the LGC board is disconnected.
3) Check if the connector pins are disconnected or the harnesses are open
circuited.
4) Check if the conductor pattern on the LGC board is short circuited or open
circuited.
5) Replace the lower drawer feed clutch.
6) Replace the LGC board.
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
5 - 6