Paper Transport Jam - Toshiba e-STUDIO281c Service Handbook

5.1.3

Paper transport jam

[E200] Upper drawer transport jam (not reaching the registration sensor)
[E210] Lower drawer transport jam (not reaching the registration sensor)
[E300] PFP upper drawer transport jam (not reaching the registration sensor)
[E330] PFP lower drawer transport jam (not reaching the registration sensor)
[E3C0] LCF transport jam (not reaching the registration sensor)
Open the jam access cover. Is there paper in front of the registration sensor?
YES
NO
Is the registration sensor working? (Perform the input check: 03-[FAX]ON/[9]/[E])
| NO
|
|
|
|
|
|
|
|
YES
Are the upper transport clutches (high/low speed) working?
(Perform the output check: 03-439, 440)
| NO
|
|
|
|
|
|
|
|
|
YES
1) Check the condition of the feed roller, separation roller and pickup roller of each paper
source, and replace them if they are worn out.
2) Check the transport roller. Replace it if it is worn out.
e-STUDIO281c/351c/451c
TROUBLESHOOTING
Remove the paper.
1) Check if the connector of the registration sensor is disconnected.
2) Check if the connector CN338 on the LGC board is disconnected.
3) Check if the connector pins are disconnected or the harnesses are open
circuited.
4) Check if the conductor pattern on the LGC board is short circuited or open
circuited.
5) Replace the registration sensor.
6) Replace the LGC board.
1) Check if the connectors of the upper transport clutches (high/low speed)
are disconnected.
2) Check if the connector CN339 on the LGC board is disconnected.
3) Check if the connector pins are disconnected or the harnesses are open
circuited.
4) Check if the conductor pattern on the LGC board is short circuited or open
circuited.
5) Replace the upper transport clutches (high/low speed).
6) Replace the LGC board.
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
5 - 10