Toshiba e-STUDIO281c Service Handbook page 28

Error code Classification
EA40 Finisher jam
(Finisher section)
EA50
EA60
EA70
EA80 Finisher jam
(Saddle stitcher sec-
tion)
EA90
EAA0
EAB0
EAC0
EAD0 Other paper jam
EAE0 Finisher jam
EAF0 Finisher jam
(Finisher section)
EB30 Finisher jam
EB50 Paper transport jam
EB60
e-STUDIO281c/351c/451c
ERROR CODE AND SELF-DIAGNOSTIC MODE
Contents
Door open jam:
1) The finisher has been released from the equip-
ment during printing. [MJ-1022]
2) The upper/front cover of the finisher section or
the upper/ front door of the puncher section has
opened during printing. [MJ-1023/1024]
3) The front cover or stationary tray cover is
opened during paper transport. [MJ-1101]
Stapling jam: Stapling is not performed properly.
[MJ-1022/1023/1024/1101]
Early arrival jam: The inlet sensor detects the paper
earlier than a specified timing. [MJ-1022/1023/
1024/1101]
Stack delivery jam: It cannot deliver the stack of
paper on the intermediary process tray to the stack
tray. [MJ-1022]
Stack exit belt home position error: The stack exit
belt is not at the home position. [MJ-1101]
Stapling jam: Stapling is not performed properly.
[MJ-1024]
Door open jam: The delivery cover or inlet cover
has opened dur-ing printing [MJ-1024].
Power-ON jam: Paper exists at No.1 paper sensor,
No. 2 paper sensor, No.3 paper sensor, vertical
path paper sensor or delivery sensor when power is
turned ON. [MJ-1024]
Transport stop jam: The paper which passed
through the inlet sensor does not reach or pass
No.1 paper sensor, No. 2 paper sensor, No.3 paper
sensor or delivery sensor. [MJ-1024]
Transport delay jam: The paper which has reached
the inlet sensor does not pass through the inlet sen-
sor. [MJ-1024]
Print end command time-out jam: The printing has
not finished normally because of the communica-
tion error between the SYS board and LGC board
at the end of printing.
Receiving time time-out jam: The printing has been
interrupted because of the communication error
between the equipment and finisher when the
paper is transported from the equipment to the fin-
isher.
Stack return jam: It cannot load the paper which
passed through the delivery roller on the intermedi-
ary process tray. [MJ-1022]
Ready time time-out jam: The equipment judges
that the paper transport to the finisher is disabled
because of the communication error between the
equipment and finisher at the start of printing.
Paper remaining on the transport path: The multiple
feeding of preceding paper caused the misfeeding
of upcoming paper.
Paper remaining on the transport path: The multiple
feeding of preceding paper caused the misfeeding
of upcoming paper (redetection after no jam is
detected at [EB50]).
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
2 - 6
07/11
Troubleshooting
P. 5-36
P. 5-38
P. 5-40
P. 5-41
P. 5-43
P. 5-43
P. 5-44
P. 5-44
P. 5-45
P. 5-47
P. 5-47
P. 5-42
P. 5-47
P. 5-16
P. 5-17