Toshiba e-STUDIO281c Service Handbook page 27

Error code Classification
E910 Finisher jam
(Bridge unit)
E920
E930
E940
E9F0 Finisher jam
(Punch unit)
EA10 Finisher jam
(Finisher section)
EA20
EA21
EA30
EA31
EA32
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Contents
Jam at the bridge unit transport sensor 1: The
paper does not reach the bridge unit transport sen-
sor 1 after it has passed the exit sensor.
Stop jam at the bridge unit transport sensor 1: The
trailing edge of the paper does not pass the bridge
unit transport sensor 1 after its leading edge has
reached the sensor.
Jam at the bridge unit transport sensor 2: The trail-
ing edge of the paper does not reach the bridge unit
transport sensor 2 after its leading edge has
reached the bridge unit transport sensor 1.
Stop jam at the bridge unit transport sensor 2: The
trailing edge of the paper does not pass the bridge
unit transport sensor 2 after its leading edge has
reached the bridge unit transport sensor 2.
Punching jam: Punching is not performed properly.
[MJ-1023/1024 (when MJ-6004 is installed)]
[MJ-1101 (when MJ-6101 is installed)]
Paper transport delay jam: The paper which has
passed the bridge
unit does not reach the inlet sensor. [MJ-1022/
1023/1024/1101]
Paper transport stop jam:
(1) The paper does not pass through the inlet sen-
sor.
[MJ-1022/1023/1024]
(2) The paper has passed through the inlet sensor
but does not reach or pass the feed path sensor
or processing tray sensor.
[MJ-1023/1024]
(3) The paper which has passed through the inlet
sensor does not reach the transport sensor.
[MJ-1101]
Paper size error jam: Paper does not reach the sen-
sor because the paper is shorter than spec. [MJ-
1101]
Power-ON jam:
(1) Paper exists at the inlet sensor when power is
turned ON.
[MJ-1022/1023/1024]
(2) Paper exists at the feed path sensor or pro-
cessing tray sensor when power is turned ON.
[MJ-1023/1024]
Transport path paper remaining jam: The paper
which has passed through the inlet sensor does not
reach the transport sensor. [MJ-1101]
Exit paper remaining jam: The paper is remaining
on the finishing tray when the power is turned ON.
[MJ-1101]
2 - 5
06/08
Troubleshooting
P. 5-29
P. 5-29
P. 5-29
P. 5-29
P. 5-46
P. 5-30
P. 5-32
P. 5-33
P. 5-34
P. 5-35
P. 5-35
e-STUDIO281c/351c/451c
ERROR CODE AND SELF-DIAGNOSTIC MODE
2