[CB31] Movable tray paper-full detection error
MJ-1101
Is there any mechanical problem when the actuator of the movable tray paper-full detection
sensor (S17) is moved?
YES
Fix the mechanism.
NO
Is there a disconnection of the connector, incorrect installation or breakage of the movable tray
paper-full detection sensor (S17)?
l
YES
•
l
•
•
NO
Is the harness between the movable tray paper-full detection sensor (S17) and the finisher
control PC board (CN13) disconnected or open circuited?
l
YES
•
•
NO
Replace the finisher control PC board.
[CB40] Rear aligning plate motor abnormality
MJ-1023/1024
Is the rear aligning plate home position sensor (PI37) normal?
NO
Correct the wiring.
YES
Is there any mechanical problem with the path of aligning plate?
NO
Fix the mechanism.
YES
1) Replace the rear aligning plate motor.
2) Replace the finisher controller PC board.
[CB40] Front alignment motor abnormality
* You receive a [CB40] error when the [ED13] error occurs three times in succession.
MJ-1101
Is there any mechanical problem when the front alignment plate is moved?
YES
Fix the mechanism.
NO
Is the harness between the front alignment motor (M9) and the finisher control PC board
(CN10) disconnected or open circuited?
l
YES
•
•
NO
Replace the front alignment motor (M9).
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Connect the connector securely.
Reinstall the sensor correctly.
Replace the sensor.
Reconnect the connector securely.
Replace the harness.
Reconnect the connector securely.
Replace the harness.
5 - 69
06/08
e-STUDIO281c/351c/451c
TROUBLESHOOTING
5