Toshiba e-STUDIO281c Service Handbook page 445

MJ-1101
Is there any paper remaining on the transport path in the finisher or equipment, or on the fin-
ishing tray?
YES Remove the paper.
NO
Is the jam cleared by taking off the staple cartridge from the finisher and removing the staple
sheet slid from the staple case?
YES End.
NO
Is there any mechanical problem when the actuator of the stapler interference sensor (S11) is
moved?
YES Reinsert the clip which fixes the actuator from the side of it.
NO
Is the harness between the stapler and the finisher control PC board (CN2) disconnected or
open circuited?
l YES •
•
NO
Are the harnesses in the stapler disconnected or open circuited?
l YES •
•
NO
Replace the finisher control PC board.
© 2005 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Reconnect the connector securely.
Replace the harness.
Reconnect the connector securely.
Replace the harness.
5 - 39
06/08
e-STUDIO281c/351c/451c
TROUBLESHOOTING
5