Canon iR105 Service Manual page 303

CHAPTER 4 INSTALLATION
No.
9 Remove the screw (w/washer) [1] from the
rear of the card reader base.
Secure the grounding wire [2] with the
removed screw (w/ washer) [1].
10 Remove the 2 screws [1] from the front of
the card reader base.
Secure the face plate [2] removed in step 4
with 2 screws [1] as shown.
11 Connect the connector [1] of the copier
and the harness of the card reader to
which a relay post heater is attached.
Push the harness into the copier, and fit in
the card reader assembly [2].
4-44
Work
COPYRIGHT© 2001 CANON INC.
Checks/remarks
[1]
[2]
F04-401-06
[1]
F04-401-07
[1]
[2]
F04-401-08
2000 2000 2000 2000 CANON iR105 REV.0 JULY 2001
[1]
[2]