Canon iR105 Service Manual page 195

6) While paying attention to the claw [2],
detach the upper arm cover [1].
7) Remove the harness clip [3].
The harness clip will divide into
two during the work. Continue
the work, as it will not ad-
versely affect any function.
8) Free the control panel harness [2] from
the 2 wire saddles [1].
9) Remove the 4 binding screws [3] and
the positioning binding screw [4]; then,
while paying attention to the claw [6],
detach the upper arm [5].
At this time, be sure to take a note of
the position of the binding screw [4].
When mounting, be sure to
match the marking [7] of the
control panel harness against
the wire saddle at the rear.
COPYRIGHT© 2001 CANON INC. 2000 2000 2000 2000 CANON iR105 REV.0 JULY 2001
CHAPTER 2 NEW FUNCTIONS
[2]
[1]
F02-804-16
[4]
[3]
[5]
[1]
[1]
F02-804-17
[3]
[4]
[5]
[6]
[7]
[2]
2-147