Canon iR105 Service Manual page 124

CHAPTER 2 NEW FUNCTIONS
4) Cut the end (excess) for the twisted
charging wire.
5) Hook the loop on the stud.
6) Hook the charging wire on the charging
wire positioner at the rear, and hook the
charging wire tension spring on the
charging wire, and twist it.
7) Cut the excess of the charging wire with
a nipper.
8) Pick the end of the charging wire ten-
sion spring with tweezers, and hook it
on the charging wire terminal. In the
case of the pre-transfer charging assem-
bly, hook the spring at the front.
Be sure of the following:
• The charging wire is free of
bends and twists.
• The charging wire is in the
bottom of the V-groove of the
charging wire positioner.
9) Fit the cushion to the front of the charg-
ing wire. (except for primary charging
assembly)
10) Mount the shielding plate (left, right).
For other charging assemblies,
fit the lid (2 pc.).
2-76
COPYRIGHT© 2001 CANON INC.
F02-508-20
F02-508-21
Grid side
(correct)
F02-508-22
2000 2000 2000 2000
(wrong)
CANON iR105 REV.0 JULY 2001