Canon iR105 Service Manual page 677

SERVICE MODE
COPIER>TEST>NETWORK
5) Make the following selections in service mode:
•
•
6) Make the following selections in service mode:
•
•
*
7) Make the following selections in service mode:
•
•
S-116
COPIER>TEST>NETWORK>PING. Enter the IP address obtained in
step 4); then, press the OK key and then the Start key.
If the connection to the network is normal, 'OK' will be indicated. (end
of work)
If 'NG' is indicated, check the physical connection of the network
cable; if normal, go to step 6).
If a fault is found in the network cable connection, correct it, and go to
step 5).
COPIER>TEST>NETWORK>PING. Then, enter the loop-back ad-
dress* (127.0.0.1); press the OK key and then the Start key.
If 'NG' is indicated, suspect a fault in the TCP/IP setting; go back to
step 3).
If 'OK' is indicated, assume that the sender's TCP/IP is free of a fault.
Instead, suspect a fault in the connection of the network interface board
(NIC) or on the NIC itself; go to step 7).
The signal returns without reaching the NIC, enabling a check on the
sender's TCP/IP setting.
COPIER>TEST>NETWORK>PING. Then, enter the load host address
(IP address of the sender), and press the OK key.
If 'NG' is indicated, suspect a fault in the NIC connector or on the NIC
itself; check the connection of the NIC, or replace it.
If 'OK' is indicated, assume that the network settings of the sender or
the NIC is free of a fault.
In this case, suspect a fault in the network environment: communicate
to the system administrator for correction.
COPYRIGHT© 2001 CANON INC. 2000 2000 2000 2000 CANON iR105 REV.0 JULY 2001