E005; E010 - Canon iR105 Service Manual

CHAPTER 6 TROUBLESHOOTING

4.1.6 E005

Web
1) Is the web of the fixing assembly taken up?
YES: Replace it with a new web.
Web detecting lever
2) Is the position of the web detecting lever correct?
NO:
DC controller PCB, Sensor
3) Is the web absent sensor (PS7) normal? (See instructions on how to
YES: Replace the DC controller PCB.
NO:

4.1.7 E010

----------
1) Are the connectors J611 and J612 of the main motor connected?
NO:
----------
2) Is the connector J1720 of the relay PCB connected?
NO:
Relay PCB
3) Close all doors. Is the voltage between connectors J1720-1 and -2
NO:
DC controller PCB, Main motor (M1)
4) Does the voltage between J514-B5 (+) and J514-B3 (-) on the DC
NO:
YES: Replace the main motor.
6-90
Correct the position of the lever.
check photointerrupters.)
Replace the sensor.
Connect the connectors.
Connect the connector.
on the relay PCB about 38 V when the power switch is tuned on?
Replace the relay PCB.
controller PCB change from 0 to about 5 V when the Start key is
pressed?
Replace the DC controller PCB.
COPYRIGHT© 2001 CANON INC. 2000 2000 2000 2000 CANON iR105 REV.0 JULY 2001