Canon iR105 Service Manual page 123

Hide thumbs Also See for iR105:

Table of Contents

c. Stringing the Charging Wire

As a rule, the charging wire (except the

grid wire) may be strung in the same way

for all charging assemblies. The following

uses the primary charging assembly as an

1) Remove the 2 screws [1], and detach the

shielding plate (left, right) [2] of the

charging assembly.

To prevent deformation (slack) of the

primary charging assembly, be sure to

work on the left and right shielding

plates separately. (Do not loosen the

screw for the left/right shielding plate.)

2) Remove the wire cleaner.

For other charging assemblies,

remove the lid (2 pc.)

3) Free a length of about 5 cm from a

charging wire reel (wire dia. of 0.06

mm), and form a loop at the end about 2

mm in diameter.

To form a loop, wind the charg-

ing wire once around a hex key,

and twist the key 3 to 4 times.

2000 2000 2000 2000

CANON iR105 REV.0 JULY 2001

CHAPTER 2 NEW FUNCTIONS

Charging wire

Chapters

Table of Contents