Canon iR105 Service Manual page 698

E067
Main cause The HV-DC PCB is faulty. The HV-AC PCB is faulty. The wiring is faulty
(short circuit, open circuit).
Condition
0000 An error is detected in two or more of the following at the same
E068
Main cause The HV-DC PCB is faulty. The HV-AC PCB is faulty. The separation charg-
ing assembly is faulty. The wiring is faulty (short circuit, open circuit).
Condition
0000 An error (leakage) to the high-voltage output to the separation
E069
Main cause The HV-DC PCB is faulty. The HV-AC PCB is faulty. The transfer charging
assembly is faulty. The wiring is faulty (short circuit, open circuit).
Condition
0000 An error (leakage) is detected in the high-voltage output to the
E100
Main cause The BD PCB is faulty. The DC controller PCB is faulty. The laser unit is
faulty. The laser driver PCB 1 is faulty. The laser driver PCB 2 is faulty. The
wiring is faulty (short circuit, open circuit).
Condition
0000 The BD signal does not arrive within 1 sec after the laser drive sig-
COPYRIGHT© 2001 CANON INC.
time: the primary high voltage, pre-transfer high voltage, transfer
high voltage, and separation high voltage. Or, an error (leakage) in
the high-voltage output to the separation charging assembly is de-
tected.
charging assembly is detected.
transfer charging assembly.
nal has been generated. Or, the BD signal does not arrive for 1 sec
or more while the laser remains ON.
2000 2000 2000 2000 CANON iR105 REV.0 JULY 2001
ERROR CODE
E-7