Fixing Heater - Canon imageRUNNER 7095 Service Manual

Chapter 9

9.5.9 Fixing Heater

9.5.9.1 Removing the Main/Sub Heater
1) Remove the fixing assembly.
2) Remove the 2 screws [1], and detach the fixing
connector unit [2]; then, remove the screw [3]
and the terminal plate [4] at the rear to pull out
the faston [5]. (2 locations)
[2]
[1]
[3] [4]
F-9-46
3) Remove the 2 screw [1], and detach the heater
positioning plate (rear) [2].
F-9-47
4) Remove the 2 fastons [1] at the front, and
remove the screw [2] to detach the heater
positioning plate (front) [3].
[3]
F-9-48
5) Remove the main/sub heater.
9-18
[1]
[3]
[4]
[5]
[5]
[1]
[2]
[1]
[2]
[1]
9.5.9.2 Mounting the Main/Sub Heater
To mount the fixing heater, reverse the steps used
to remove it with the following in mind:
0010-9454
a. Do not touch the surface of the heater.
b. For both, mount the heater so that the side with
the longer harness is to the front.
c. Viewing from the front of the fixing assembly,
mount the main heater [1] to the right and the
sub heater [2] to the left.
9.5.9.3 Points to Note When Mounting the
Fixing Heater
1. Do not touch the heater surface.
2. For both heaters, mount so that the side with
the longer heater harness is toward the front.
3. Viewing from the front of the fixing assembly,
mount the main heater on the right (for 200V
model, 1150 W; for 208V model, 1220 W; for
230V model, 1185 W) and the sub heater on the
left (for 200V model, 565 W; for 208V model,
600 W; for 230V model, 645 W).
4. Viewing from the rear, connect the right side of
the faston of the heater at the rear to the main
heater, and connect the top side to the sub
heater.
Height of the Fixing Inlet Guide
5.8mm
(reference only)
Fixing screw
Do not loosen the fixing screw on the inlet guide,
as you will have to adjust the position of the inlet
guide if you remove the inlet guide base. If you
must loosen it, be sure to adjust the position of the
inlet guide afterward by referring to the index on
the fixing assembly.
[1]
[2]
F-9-49
(reference only)
Fixing screw
F-9-50
0010-9532
0010-9533
5.8mm