Mounting The Scanner System - Canon imageRUNNER 7095 Service Manual

11) Remove the 2 pins [2] taped in place to the
slope plate [1].
Turn over the slope plate [1], and match the pin
hole of the skid and the pin hole of the slope
plate; then, fit a pin [2] (1 pc. each) through the
holes.
Holding the grips (front, rear) on the delivery
side of the machine, move the machine off the
skid by sliding it along the slope plates.
F-2-14
12) Remove the grip [1] fitted in step 4) while
pushing the leaf spring with a flat-blade
screwdriver.
[1]
F-2-15
13) Remove the packing tape from the machine.
14) Open the front cover [1].
[2]
[1]
15) Open the compartment cover [2] found
behind the front cover, and put in the grip [3]
for storage.
F-2-16
16) Open the upper right cover, and mount the
face cover (small, large).
17) Close the upper right cover.
If condensation is found on the outside or inside
of the machine at this point, stop the work and
wait unit the machine becomes fully used to the
room temperature. Resume the work after making
sure that the machine is free of condensation.

2.2.3 Mounting the Scanner System

1) Open the ADF.
Remove the copyboard glass protective pad
and tape.
2) Remove the scanner system fixing screw [1].
(Store the screw away for possible relocation of
the machine in the future.)
[1]
F-2-17
Chapter 2
[2]
[3]
[1]
0010-8943
2-9